FILLER FOR PLASTIC MATERIALS 500G

BRAND BLUE-CAR

Two-component filler for plastics has very high flexibility and excellent adhesion to most plastics (except polyethylene and Teflon).

It also has satisfactory adhesion to polypropylene, allowing for filling unprimed surfaces.

SUBSTRATES USED:

• Old paint coatings
• Two-component acrylic primers
• Steel
• Aluminum
• Galvanized steel
• Plastics excluding PE and PTFE

HOW TO USE:

• Thoroughly sand, clean, and degrease, then dry the areas to be covered with the filler.
• Mix the selected amount of filler with the appropriate amount of hardener specified on the packaging. Do not exceed the recommended dose of hardener.
• Apply with a spatula for 4-6 minutes at 20°C.
• Drying time is about 30 minutes at 20°C.

Mixing ratio with hardener by weight: 100g of filler + 2g of hardener.

Pre-sanding: P80-P120

Finishing sanding: P120-P240